Papers
1. Brushless DC Motors for Winchester Disc Drives
Intermag 1985, St. Paul, MN
2. The impact of high speed iron losses on BLDC motor operation at speeds above 10,000 rpm
Seventeenth Annual Symposium on IMCSD, Champaign, IL, June 1988 (with Dan Jones).
3. Magnetic design of brush and brushless DC motors through lumped reluctance & FEM simulation programs
Satech 1988, Dearborn, MI, October 1988 (with Dan Jones).
4. Brushless DC motor operation at high speeds as affected by the core losses
Drives/Motors/Controls/Programmable Controllers Interface 1988, Birmingham, England, November 1988
(with Dan Jones).
5. Computer program aids magnetic design of brush and brushless DC motors
PCIM, January 1989 (with Dan Jones).
6. Brushless DC motors for rigid disk drives
Motion Control Handbook, Designfax, May 1989.
7. Magnetizing fixture provides 3-D flux flow
PCIM, July 1989 (with Joe Stupak).
8. Voice-Coil Actuators
Designfax, September 1989 (with Joe Stupak).
9. Voice-Coil Actuators: Insight into the Design
PCIM 1989 conference, Long Beach, CA, October 1989 (with Joe Stupak).
10. Optimal Design of Magnetizing Fixtures
IMCSD conference, San Jose, CA, June 1990 (with Joe Stupak).
11. A Review of Steel Materials in Motion Devices
PCIM 1990 conference, Philadelphia, PA, October 1990 (with Joe Stupak).
12. Engine Management for Hybrid Electric vehicles
EVS-10 conference, Hong Kong, December 1990 (with Craig Cambier).
13. The Use of Powdered Metals in DC Motors
IMCSD conference, San Jose, CA, June 1992 (with Joe Stupak).
14. Fixtures for Straight-through magnetizing
IMCSD conference, San Jose, CA, June 1993 (with Joe Stupak).
15. Radially Oriented Magnet Rings
PCIM 1993 conference, Irvine, CA, October 1993 (with Joe Stupak).
16. Flux-Density/Coercivity (B/H) of Round Rod Magnets in Air
IMCSD conference, San Jose, CA, June 1994 (with Joe Stupak).
17. Motor Design Advancement Using NdFeB Magnets
Ninth international business conference for magnet procedures, users, and raw material suppliers,
San Diego, CA, February 1995.